![]() Make sure the vent on the incubator is open. ![]() Make sure it is away from bathrooms, kitchens, or the room in which you dry your laundry. If the incubator is in a room where the humidity is naturally quite high, then move the incubator to another location. 'How do I monitor the humidity in a incubator which does not have a humidity read out/display'? If your incubator has manual humidity control without a display, you may find the question below more helpful: Here a few things you can do to combat it. There are a few things which can cause the humidity in your incubator to go too high. If you are still experiencing issues with getting your humidity high enough in a incubator with automatic humidity control then please contact us here. If the pump is working check the tubing and replace if necessary. Set the humidity level as high as possible to try and force a pump, look to see if the motor turns or on some incubators like the Rcom 10 Pro + and Rcom King Suro Max 20 you can test the pump by pressing and holding the + for 5 seconds. If the reading is below the set level, then this could indicate an issue. For incubators with pumps ensure the pump is working.The pump will drop water onto the pad which spread out, increasing the surface area of water, and therefore increasing the humidity. Make sure you are using humidity blocks or pads with the incubator if has a humidity pump.If you have a incubator like the Rcom 20 Max, Rcom 20 Pro, Rcom 50 Max, or Rcom 50 Pro which has a built-in humidity heater ensure there is water in the incubator for it to heat up. Also check that the tube is in the water supply or for the Brinsea Advance pump ensure there Is water in the pump. Check for air bubbles, splits, or blockages like scale if you use tap water. If the incubator uses a pump, ensure the tubing is not blocked.If the event is open, you are allowing that much needed moisture in the incubator to escape. ![]() Make sure the vent on the incubator is closed.Cold air will draw moisture out of the incubator so ensure the room is warm and the incubator is not exposed to wide room temperature changes or a draught is essential to having the humidity level you need. A cold room will make it so much harder for you achieve the humidity level you want. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |